888.243.9445 M-F 6AM-7PM CT

Free shipping over $100

E-conolight PAR20 Incandescent Surface Mount Light

Ruud PAR20 Incandescent Surface Mount

Review configuration
Specs & Guide


LIMITED SUPPLY - Ruud black surface mount directional flood. Flat profile takes a PAR20 50 Watt max incandescent lamp (Order Lamp Separately). Junction box cover not included. If you liked this product try these.



Fluorescent and some high intensity discharge (HID) lamps contain mercury, a hazardous substance regulated by Federal and State laws. Lamps that contain mercury will be marked with a circled "Hg" and “Contains Mercury”. These lamps must be recycled or disposed in accordance with local, state or federal law. For more information visit www.lamprecycle.com. If you are not the end user of these lamps you may be required by law to inform the purchaser that these lamps contain mercury and must be properly disposed or recycled. Check your State and Local laws for compliance.

Recommended Use

For accenting architecture or lighting landscape areas.
50W Max
  • Ruud Single Mount Junction Box Cover
    Ruud Single Mount Junction Box Cover
  • Ruud Dual Mount Junction Box Cover
    Ruud Dual Mount Junction Box Cover
  • Photocell - Button, 120V
    Photocell - Button, 120V
  • Ruud Mounting Box with Stake, Cord & Plug
    Ruud Mounting Box with Stake, Cord & Plug
  • Ruud Conduit Slip Fitter - Black
    Ruud Conduit Slip Fitter - Black

How do you remove lights from a Rudd PAR20 Incandescent Surface Mount landscape lighting? The lights are stuck and there is no leverage to turn the light bulb.

Asked by: JoeyT
To relamp the fixture, loosen allen set screws & remove lens assembly. After doing so, remove old lamp and install new one. For more details please see the "Relamping Fixture" section in our instruction manual: http://www.e-conolight.com/pdf/Instructions/CI196X02.PDF
Answered by: Lauren P
Date published: 2016-12-28

what is the beam width?

Asked by: hamilton
The beam width is based on the lamp used (lamps sold separately).
Answered by: Ashley H
Date published: 2015-12-21

how do you change a bulb in a PAR20 incandescent

Asked by: jimmyz64
Please refer to the instruction manual, which can always be found on the spec & guide tab.
Answered by: Nikki
Date published: 2015-02-23

Can an LED light bulb be used in this fixture? Can I order stakes so it can be installed in the ground? Will it work with a 110v/120v wiring system?

Asked by: Jennifer
This fixture requires a PAR20 50 Watt max incandescent lamp. We would suggest you use a ground mount post (http://www.e-conolight.com/e-acgm1k.html). You could also use a mounting box with stake (http://www.e-conolight.com/e-gamnb2k.html), which has a 10' cord that is fully gasketed with 120V straight blade plug.
Answered by: Nikki
Date published: 2014-09-03
  • y_2017, m_11, d_19, h_1CST
  • bvseo_bulk, prod_bvqa, vn_bulk_2.0.3
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_4
  • loc_en_US, sid_E-GLSP20F1K, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_econolight